- Install
- Make sure to disconnect the Nemonic Label printer from your Mac PC before installing the program.
If you install the program while the Nemonic Label printer is connected to the Mac PC with a USB cable, an error may occur. 
- Click on the link below to download the installation file.
-
Download the Installation File
Link: Nemonic PC App & Driver Package - Run the installation file.
Read terms and conditions, and check “I agree” to continue the installation.After installation, connect the Nemonic Label printer to your Mac PC.
- Make sure to disconnect the Nemonic Label printer from your Mac PC before installing the program.
- Connect
- Use the USB cable provided to connect the printer to your Mac PC.
The cable provided by standard is a USB A to A cable.If your PC has USB C type ports only, use a USB hub.
- Use the USB cable provided to connect the printer to your Mac PC.
- Use the Nemonic App
- Find and run the Nemonic program. A window appears as below.
Click on the Options Menu icon to open the submenu. 
- Click on the Change Memo Size icon repeatedly from the submenu to change the paper size.
3” x 2” paper is provided by standard on printer purchase. 
- The program window will be resized.
Enter a test content and click on the Print icon. 
- If the program is correctly installed, it will be printed within two to three seconds.
-
If not printed, you may check two cases as follows:
- Program installation error
- Delete the program and install it again.
- USB cable connection error
- If you are using a cable other than provided, use one that is as short as possible.
- If you are using a hub, use a powered one.
- Program installation error
- If not printed, refer to the below link.
-
- Find and run the Nemonic program. A window appears as below.
